Uniden DSS7955+1 - Manual (Page 43)

42
The “T-coil” mode icon will no longer appear on the handset LCD display.
Note: Using the T-coil mode may shorten the amount of time you can talk on your handset between battery charges.
Therefore it is recommended that the handset be returned to the charging cradle when not in use. If this feature is
not required, the “T-coil” mode should not be turned on.
Finding.a.Lost.Handset
To locate a misplaced handset, press [flash/find handset] on the base when the phone is in standby. All registered
handsets will beep for 60 seconds, and PAGING appears on the handset display. To cancel paging, press [flash/find
handset].on the base.
Note: If the battery pack is completely drained, the handset will not beep when paging.
Using.Hold,.Conference.and.Transfer
Placing.a.Call.on.Hold
During a call, press [int’com/hold] on the station to place the caller on hold. If you leave a caller on hold for
more than ten seconds, the display screen will read, LINE ON HOLD.
To return to the party on hold, press
[ /flash] or [ ] on a handset or [ ] on the base. The phone will return
to the holding party.
Note:
You can only place a caller on hold for 5 minutes. Once 5 minutes has passed, that party’s line will be
disconnected and the phone will return to standby.
While a call is on hold, Caller ID and Call Waiting cannot be received.
Conferencing
If you have more than one handset, up to four people can participate in a conference call. A four-way conference call
consists of an outside line, two handsets, and the base speakerphone. You can easily join a call already in progress.
Press [ /flash] or [ ] on the handset or [ ] on the base to join the call.
To hang up, return the handset to the cradle or press [ ] on the handset or [ ] on the base. The other party
will still be connected to the call.
2)
)
2)
•
•
)
2)