Uniden DSS7955+1 - Manual (Page 20)

9
Installing.the.Belt.Clip
Line up the holes on each side of the handset. To attach the belt clip, insert into the holes on
each side of the handset. Press down until it clicks.
To remove the belt clip, pull either side of the belt clip to release the tabs from the holes.
Connecting.to.the.Phone.Line.
Once the handset battery pack is fully charged, connect the
telephone cord to the TEL LINE jack and to a telephone outlet.
Testing.the.connection
To test your connection, try making a call. If your call connects,
the settings are fine. If your call does not connect, check the following:
Check to see that the AC adaptor cord is securely connected to the DC IN 9V jack and to a standard AC
power outlet.
Check to make sure the battery is fully charged. (If you don’t see the “battery full” icon, check to make sure
the battery is properly connected.)
Change dial mode (instructions on page 20).
)
2)
)
2)
3)
To telephone outlet
To TEL LINE
TEL Cord
Telephone line cord (supplied)
To telephone outlet
To TEL LINE
TEL Cord
Telephone line cord (supplied)