Uniden DSS7955+1 - Manual (Page 70)

69
Changing.the.Digital.Security.Code
The digital security code is an identification code used to connect the handset and the base. Your unit ships from the
manufacturer with a preset security code. Resetting this code is not normally necessary. In the rare situation that you
suspect another cordless telephone is using the same security code or if you are instructed to change this code by a
manufacturer’s Call Center Representative, you can change the code by:
Perform “Resetting the Handset” for all of your handsets by following the steps on page 26.
Re-register each handset by placing in the base charging cradle.
Traveling.Out.of.Range
During a call, if you move your handset too far away from your base, noise may increase. If you pass the range limits
of the base, you will hear a beep and see OUT OF RANGE on the display, and then the handset returns to standby.
Common.Issues
If your phone is not performing to your expectations, please try these simple steps first. If these steps do not solve
your problem, please call our Customer Hotline. See back cover page for contact information.
Symptom Suggestion
The charge/in use LED won’t
illuminate when the handset
is placed in the cradle.
Make sure the AC adaptor is plugged into the base or the charger (if you have
more than one handset) and wall outlet.
Make sure the handset is properly seated in the cradle.
Make sure the charging contacts on the handset are clean.
•
•
•
The audio sounds weak. Move the handset and/or base away from metal objects or appliances and try
again.
Make sure that you are not too far from the base.
•
•
.
2.