Toshiba MW26H82 - Manual (Page 55)

55
Other functions (VCR)
Other functions (VCR)
Press INPUT repeatedly to select VIDEO1 or
VIDEO2.
To AUDIO (R) IN
To AUDIO (L) OUT Audio/Video cable (not supplied)
Playback VCR
To VIDEO OUT To AUDIO (R) OUT
Recording VCR
Duplicating a video tape
If you connect the unit to another VCR or Camcorder, you can
duplicate a previously recorded tape. Make all connections before
turning on the power.
Duplicating a video tape
For duplicating a previously recorded tape from a
camcorder, follow the camcorder manufacturer’s
instructions. A typical camcorder dubbing hookup is
shown above.
Audio/Video cable (not supplied)
To AUDIO (R) IN
To AUDIO (L) IN
To VIDEO IN
Recording VCR
To AV Jack
Playback Camcorder
Connection with Camcorder
• Select “VIDEO2” on step 2.
1
Press PLAY on the playback VCR or camcorder.
3 Press REC.
4
Press STOP when you finish after duplicating. 5
VIDEO1: on
the rear panel
VIDEO2: on
the front panel
Preparation:
• Press TV/VCR to select the TV/VCR mode.
• Load a cassette tape with the erase prevention tab
intact.
• Load a previously recorded tape into the playback
VCR or Camcorder.
To VIDEO IN
To AUDIO (L) IN
Connection with second video recorder
• Select “VIDEO1” on step 2.
TV/VCR
INPUT
STOP
REC
SPEED
The unauthorized recording, use, distribution, or revision of
television programs, videotapes, DVDs and other materials,
is prohibited under the Copyright Laws of the United States
and other countries, and may subject you to civil and/or crimi-
nal liability.
2
Press SPEED to select the desired tape speed
SP or SLP.
It is recommended to set the Speed to
the SP mode on the recording VCR
for best results.
SOURCE SELECTION
0. ANT
1. VIDEO1
2. VIDEO2
3. ColorStream HD
4. HDMI
/ 0-4:SELECT
5V90101A [E]p52-56 8/4/06, 5:47 PM 55