Technicolor - Thomson STUDIO CAMERA LDK 20(S) - Manual (Page 14)

2-6 Technical Manual LDK 20(S) - Studio Camera Installation
Viewfinder Cadre Indication
Cadre On/Off
Switch S6 on the Sync./shading board allows the
cadre in the viewfinder to be switched on permanently
or to be controlled by the menu system. Position AB
selects (remote-) menu control (factory setting);
position AC switches the cadre on permanently.
If S6 is in the remote position then you can select in
Menu VF/Lens Cadre On or Off. The cadre is switched
to the 4:3 format or to the 16:9 format depending on the
position of the aspect ratio switch. Cadre appearance
Switch S7 on the Sync./shading board allows the
cadre in the viewfinder to take the form of two dotted
lines or two low-contrast areas outside the picture
area. Position AB selects the dotted lines; position AC
selects the low-contrast areas.
The contrast of the cadre strips is adjusted with
potentiometer ZR247 on the Video/Miscellaneous
board.
16:9
dotted
lines
low-contrast area
low-contrast area
4:3
low-contrast areas
dotted lines
X
1
7
A
X
1
7
B
TOP SIDE Video / Miscellaneous board
ZR247
Cadre
contrast
X
6
1
X
6
2
TOP SIDE Sync / Shading board
S7
C A B
S6
C
A
B