Tiger Products Co., Ltd 6020009 - Manual (Page 64)

Twin Rtry Maintenance Section 4-2
MAINTENANCE
Tiger Mowers are designed for high performance and rugged durability, yet with
simplified maintenance. The purpose of this section of the manual is to help the
operator in the regular servicing of the mower. Regular maintenance at the
intervals mentioned will result in the maximum efficiency and long life of the Tiger
Mower.
When you purchase a Tiger Mower you also acquire another valuable asset,
Tiger’s parts organization. Our rapid and efficient service has guaranteed the
customer satisfaction for many years. Tiger parts keep up with the demands for
efficiency, safety and endurance expected of the Tiger Mower.
BREAK IN PERIOD
MAINTENANCE PRECAUTIONS
In addition to following the break in instructions for your particular tractor, the in-tank
hydraulic fluid filter should be replaced after the first 50 hours of service. Thereafter
the filter should be replaced every 500 hours, or yearly, which ever comes first.
Re-torque wheel lugs after first five hours of operation and periodically
thereafter. See torque specifications listed in the tractor’s service manual for your
particular model. Wheel lugs must always be re-torqued whenever a wheel is
removed and reinstalled.
Be sure end of grease gun and zerks are clean before using. Debris injected
intobearings, etc. with grease will cause immediate damage.
·
DO NOT use a power grease gun to lubricate bearings. These require very
small and exact amounts of lubrication. Refer to the detailed maintenance section
for specificlubrication instructions. Do Not over-grease bearings.
·
Lexan windows should be washed with mild soap or detergent and luke warm
water, using a soft clean sponge or soft cloth. DO NOT use abrasive or alkaline
cleaners or metal scrapers on lexan windows!
·
Be alert to maintenance indicators such as the in-tank filter pressure gauge,
hydraulic reservoir sight gauge, etc. Take the required action to correct any
problems immediately.
·
Release of energy from pressurized systems may cause inadvertent actuation
of cylinders, or sudden release of compressed springs. Before disconnecting any
hoses relieve pressure by shutting tractor off, setting cutter on ground and actuating
lift valve handles.
DO NOT use hands to check for suspected leaks in hydraulic hoses!
Hydraulic fluid escaping under pressure can have sufficient force to
penetrate skin and cause serious injury. If fluid is injected into skin, it
must be surgically removed within a few hours or gangrene may result.
Use a small piece of wood or cardboard, not hands, to search for pin
hose leaks. Be sure all pressure is relieved whenever disconnecting
lines. Be sure all connections are tight and hoses and lines are not
damaged before applying pressure.