Tiger Products Co., Ltd 6020009 - Manual (Page 39)

Assembly Section 2-13
ASSEMBLY
INSTALLING O-RING FITTINGS
Installing straight, 45 degree and 90 degree O-ring fittings requires that the O-
ring, washer and nut (A) be up against the swivel body (B). Insert the swivel and
turn in until the swivel is pointed in the right direction and the O-ring contact is
made. Hold swivel in set direction with a wrench and turn the O-ring nut away
from the swivel body and carefully tighten.
SUB-FRAME AXLE BRACE MTG.
These units require the lower rear axle brace to be mounted under the right
rear axle of the tractor. The other end of the axle brace mounts to the main frame
lower right rear corner. Some shims may be required for proper fit of the main
frame to the tractor, see main frame mounting in the part section on this manual.
With all sub-frame connections hardware in place, it should fit tightly and level
under the tractor. Be sure to use a thread locking agent on all capscrews and nuts
that attach the frame to the tractor.