Toshiba TEC MA-186 - Manual (Page 81)

- 75 -
EO1-11115
MA-186-100 SERIES
Address: 7
Initial SET Bit Nos.
→
1 3
Your Selection
→
([CHK TND] Key Function)
Content
Bit
No.
Selective Status
RESET SET
Tender and Total Functions in finalizing a sale in REG
mode
-- vacant --
Cashing with no purchase, using this key
Over-tendering (tendering an amount larger than the sale
total, resulting in calculation of change due)
-- vacant --
1
2
3
4
5 to 8
PROHIBITED ALLOWED
TENDER or
TOTAL
TENDER only
ALLOWED PROHIBITED
Supplementary Description for Address 7:
Bit 1: Refer to the “Supplementary Description” of Bit 1 attached to Address 6 on the
preceding page.
Bit 3: RESET status .................... Customers’ checks cannot be cashed outside a sale.
SET status .......................... Customers’ checks can be cashed with no purchase
outside a sale.
Bit 4: This Bit status selection is effective only in tendering operation.
SET status .......................... If this bit is SET and also Address 11 - Bit 1 is SET (for
Short-tendering Prohibited), an amount equal to the sale
total is always required for tendering.