Toshiba TEC MA-186 - Manual (Page 41)

- 35 -
EO1-11115
MA-186-100 SERIES
ex.) .......... indicates $ 39.99 .......... Allows to enter equal to or smaller than
$39.99 in sale entries.
Department LC (Listing Capacity) Programming:
The LC setting is used to check an amount limit error. By setting the LC, an amount entry (due perhaps
to a mistake by the operator) will be prevented at the earliest stage (i.e., an error will result on entering
an excessive amount through the department key).
Condition: After Daily Financial Reset (refer to “NOTE on Condition” on page 15)
Programming Procedure:
Use the MA Key to turn the Control Lock to “SET”.
Z OFF
X
REG
SET
→ →
2-digit LC code for
each department Common 2-digit LC code for
all departments
NOTES 1, 2 NOTES 1, 2
4 digits
Value of the top digit
Declaration of Program No. 8 for Department LC programming
Repeat for setting LCs of other departments.
To designate the
Department
Nos. 21 to 40.
( )
AT/TL
8 @/FOR
→
DPT
SHIFT
→ → → → →
4 3
NOTES: 1. If the individual LC of a department is set, it prevails over the common LC for all departments.
2. To reset a LC once set, enter “0” in place of the 2-digit LC code. Then a maximum of 7-digit amount
can be entered in sale entries.
Department LC Program Receipt Format:
Key Operation
Control Lock: SET
3
8 @/FOR
4
6
0
Top digit value
Thank you
Call again
05.- 28.- 9 7
0.8 ★
0 1 7 3
0 2 9 4
0 3 5 7
0 4 0 0
8 6
0 01.1
0 8 - 5 2
Number of
maximum digits
Common LC for all departments
Listing Capacity Code
for each department
4
7
9
5
8 AT/TL
Dept. 4
Dept. 3
Dept. 2
Dept. 1
Dept.