Toshiba TEC MA-186 - Manual (Page 111)

- 105 -
EO1-11115
MA-186-100 SERIES
Depress the following Numeric Key according to the display and print format for zero amount:
Sales Memory Clear
The operation defined as “Sales Memory Clear” will only clear the sales data accumlated in the register’s
memory (report memory). The programmed data will not be cleared. By operating a Sales Memory Clear
, all the sales data including non-resettable totals and counters, Reset Report Counts, Receipt Consecutive
No., and Electronic Journal memory are cleared.
Warning: This clear operation deletes all sales data stored in the register’s memory.
Operating Procedure
Condition: Any time, outside or during any operation sequence except during Key Setting or Key Location
Changing or System Option Setting procedure.
Operation:
Use the S Key to turn the
Control Lock to “BLIND”.
Numeric Key
Sales Memory Clear Symbol Line
(03 for Numeric 3, 01 for Numeric 1)
Receipt Consecutive No. is reset
to 0001.
(Date and Time remain unreset.)
Zero-amount Display & Print Format
designated here.
1
3
Z OFF
X
REG
SET (BLIND)
Zero-amount
Format
0 . 0 0
. 0
Thank you
Call again
05.- 28.- 9 7
0 3 ★0.0 0
0 00.1
1 3 - 0 4
for use in US or Canada
AT/TL Depress the key.
A Sales Memory Clear receipt is issued.
NOTE: When a Sales Memory Clear is operated, the condition “after all sales data reset” is obtained, just as
“Status Clear” or “All Memory Clear”. Therefore, no Reset Reports need to be taken for starting any
programming operation.