Texas Memory Systems RamSan-325/325c - Manual (Page 32)

RamSan-325/325c User’s Manual - 28 -
Talk to your network administrator for the proper IP assignment
type. The default factory setting is DHCP. Use the “Select” button
to select the desired method of IP assignment. If you did not
choose “Static IP” you are asked to confirm the selection with the
“↓” button.
To configure the RamSan with a static IP, the system requires the
IP address, subnet mask, and a possibly a gateway address.
After you have chosen
“Static IP,” “Ethernet IP”
replaces the top line of the
display, and the display
prompts you to enter an IP.
Use the “↑” or “↓” buttons
to cycle through the
numbers “0” through “9”.
To select the value, use the
“Select” button. Then, the
input prompt moves to the
next character position. To
back up a space, press the
“↑” and “↓” button
simultaneously. Repeat this
procedure until you have
entered the 4-byte address.
Press the “Menu” button at
any time to cancel the
Static IP assignment.
After you have finished
entering the IP, the top line
of the front panel changes
to “Subnet Mask.” Using
the same procedure as
entering the IP address,
enter the subnet mask.
The final value you must
enter is the “Gateway
Address.” If the RamSan is
on a private network and
this value is not needed,
enter the value “0.0.0.0” to
tell the RamSan to ignore
this entry.
After entering all three values, the display prompts you to confirm
the command with the “↓” button.
Ethernet IP
_
Subnet Mask
_
Gateway Address
_