Tyan Computer Barebone System B4881V50S4H - Manual (Page 29)

2.3 Installing hard drives
Chapter 2: Setting up 21
2.3.1 Installing a storage backplane
The B4881V50S4H is shipped with a single SATA backplane
installed that can support up to four hot-swap SATA hard
disks. A second SATA backplane can be installed or a similar
SCSI backplane can be installed. The installation process for
SCSI and SATA backplane is the same.
Note:
Up to 8 hot-swap SCSI or SATA drives
can be supported when two backplanes
are installed.
To install a storage backplane:
1. Remove the chassis cover. See Removing the chassis
cover on page 13.
2. Remove the two screws holding the cradle locking bar in
place and remove the bar.
3. Lift the drive housing to the vertical position.