Technicolor - Thomson VMD 22 - Manual (Page 32)

E N
3 1
1
D
S
5
T
W
W
F
F
R
I
E
S
E
I
I
L
L
E
S
L
L
D
N
A
A
M
T
F
E
E
D
S
S
A
U
–
H
H
N
R
T
M
M
C
U
N
I
A
O
U
A
A
M
C
D
T
D
L
E
R
E
J
R
O
.
MEN
2
U
Flash Brightness Adjustment
When a snapshot (
੬
pg. 18, 19) is taken in the dark the
camcorder fires the flash (
੬
pg. 30) and adjusts the
brightness automatically. You can also adjust the flash
brightness manually. When you find that the snapshots
you took look too bright or too dark, adjust it manually.
1 Set the Operation Switch to “ ” and set the POWER
Switch to “ ” while pressing down the Lock
Button located on the switch, then pull out the
viewfinder or open the LCD monitor fully.
2 Press the MENU wheel. The Menu Screen appears.
3 Rotate the MENU wheel to select “ ”, and press it.
“MANUAL MENU” appears.
4 Rotate the MENU wheel to select “FLASH ADJ.”, and
press it. The parameter appears.
5 To intensify the flash, rotate the MENU wheel towards
“+”. To weaken the flash, rotate it towards “–”.
Adjustment range: –3 to +3.
6 Press the MENU wheel. Rotate it to select
“1RETURN” and press it twice to close the Menu
Screen.
NOTE:
When you change the subject you are shooting or the
shooting location, set it back to
±
0 as described in step 5
and take a snapshot to check the flash brightness. After
doing this adjust to your desired brightness.
POWER Switch
MENU Wheel
Menu Screen
Operation Switch
Display
Lock Button
VMD22 EN(02/33) 29/08/00, 14:42 31