Technicolor - Thomson VMD 22 - Manual (Page 21)

20
EN
1 0 x W T
1 xW T
1 0 xW T
20xW T
40xW T
RECORDING Basic Recording For Video And D.S.C.
Zoom in (T: Telephoto)
Zoom out (W: Wide angle)
Power Zoom Lever
Zoom display
FEATURE: Zooming
PURPOSE:
To produce the zoom in/out effect, or an instantaneous
change in image magnification.
OPERATION:
Zoom In
Slide the Power Zoom Lever towards “T”.
Zoom Out
Slide the Power Zoom Lever towards “W”.
Ⅲ The further you slide the Power Zoom Lever, the
quicker the zoom action.
NOTES:
● Focusing may become unstable during Zooming. In
this case, set the zoom while in Record-Standby,
lock the focus by using the manual focus
(
੬
pg. 25), then zoom in or out in Record mode.
● Zooming is possible to a maximum of 200X, or it
can be switched to 10X magnification using the
optical zoom (
੬
pg. 27).
● Zoom magnification of over 10X is done through
Digital image processing, and is therefore called
Digital Zoom.
● During Digital zoom, the quality of image may
suffer.
● Digital zoom cannot be used in the following cases:
• When digital image processing, such as Picture
Wipe/Dissolve (
੬
pg. 34, 35) or Video Echo
(
੬
pg. 36), is activated.
• When the MODE Dial is set to “ DUAL or “ ”.
● Macro shooting (as close as approx. 5 cm to the
subject) is possible when the Power Zoom Lever is
set all the way to “W”. Also see “TELE MACRO” in
the Menu Screen on page 28.
Approximate zoom ratio
Digital zoom
zone
10X (optical)
zoom zone
POWER Switch
VMD22 EN(02/33) 29/08/00, 14:41 20