Technicolor - Thomson VMD 22 - Manual (Page 10)

E N
9
4
FAD
W
W
R
O
F
F
F
E
I
I
A
F
A
A
A
R
P
P
N
F
D
D
D
/
E
E
D
E
E
E
W
–
–
O
R
R
R
I
S
S
M
–
–
–
P
C
H
W
B
B
E
R
U
H
L
.
O
T
I
A
W
L
T
T
C
L
E
E
K
R
1
O
D
T
C
R
N
A
I
L
D
E
T
M
O
A
I
T
S
E
E
C
D
S
U
C
/
K
J
P
R
R
T
C
.
L
N
E
I
O
A
E
M
D
Y
N
E
E
MEN
1
U
.
1
1
2 .
:
0
0 0
0
Date/Time Settings
The date/time is recorded onto the tape at all times, but its
display can be turned on or off during playback (
੬
pg. 41).
1 Set the Operation Switch to “ ” and set the POWER
Switch to “ ” while pressing down the Lock
Button located on the switch, then open the LCD
monitor fully or pull out the viewfinder fully. The
POWER lamp lights and the camcorder is turned on.
2 Press the MENU wheel. The Menu Screen appears.
3 Rotate the MENU wheel to select “ ”. Press it and
“DISPLAY MENU” appears.
4 Rotate the MENU wheel to select “CLOCK ADJ.”.
Press it and “day” is highlighted.
Rotate the MENU wheel to input the day. Press it.
Repeat to input the month, year, hour and minute.
Rotate the MENU wheel to select “1RETURN”, and
press it twice. The Menu Screen closes.
Built-in Clock’s Rechargeable Lithium Battery
To store the date/time in memory, the clock’s rechargeable
lithium battery is integrated in the camcorder. While the
camcorder is connected to an AC outlet using the AC
Power Adapter/Charger, or while the battery pack attached
to the camcorder continues to supply power, the clock’s
rechargeable lithium battery is always charged. However,
if the camcorder is not used for approx. 3 months, the
clock’s lithium battery will become discharged and the
date/time stored in memory will be lost. When this occurs,
first connect the camcorder to an AC outlet using the AC
Power Adapter/Charger for over 24 hours to charge the
clock’s rechargeable lithium battery. Then perform the
date/time setting before using the camcorder.
Note that the camcorder can be used without setting the
date/time.
NOTE:
Even if you select “CLOCK ADJ.”, if the parameter is not
highlighted the camcorder’s internal clock continues to
operate. Once you move the highlight bar to the first date/
time parameter (day), the clock stops. When you finish
setting the minute and press the MENU wheel, the date
and time begin operation from the date and time you just
set.
Display
MENU Wheel
POWER Switch
DISPLAY MENU
POWER Lamp
Operation
Switch
Lock Button
VMD22 EN(02/33) 29/08/00, 14:40 9