Toshiba TOSLINE S20 - Manual (Page 26)

TOSLINE-S20 Active Star Coupler (ASC25) Instruction Manual 6F3B0360
TOSLINE S20 25
9. Installation and Wiring
9.1 Method for mounting the main unit
The Active Star Coupler may be installed within a cubicle, on a table, or onto a panel.
(1) Installation in a cubicle
Unit: mm
Cubicle
Active Star Coupler
L-shape
bracket
Base for the unit
Support for the unit
Figure 9.1 Installation of Active Star Coupler in a cubicle
Using L-shape brackets and M5 screws (12 to 20 mm in length), mount the Active Star
Coupler main unit to the base for the unit.
In that case, remove the rubber feet at the bottom of the Active Star Coupler. The L-
shape brackets have already been attached to the main unit of Active Star Coupler.
(2) Installation on a table
For the case of installation of Active Star Coupler on a table, place the Active Star Coupler
on the table. The Active Star Coupler is equipped with rubber feet at the bottom. If the attached
L-shape bracket is unwanted, remove them by detaching the screws at the sides of the main unit.
After removing the L-shape brackets, retighten the once detached screws.
(Note) Do not stack the Active Star Couplers because the Coupler is not designed to have
strength bearing that weight.