Toshiba TOSLINE S20 User Manual
Page 24
TOSLINE-S20 Active Star Coupler (ASC25) Instruction Manual
6F3B0360
TOSLINE S20
23
8.
Precautions on using Active Star Coupler
(1)
Precautions on the function of preventive means to single-wire breaking
Observe the following-listed cautions on using the function of preventive mean to single-
wire breaking.
•
Even if the function is set, it is not actuated for about 10 seconds after power "ON".
•
In the case that the power is "ON" while the function was not set, when the function is set in
that state, (or when the switch is turned to "ON" position), the function is not actuated for
about 10 seconds after the switch is turned "ON", and after that, the function is actuated.
•
In the case that ASC25s are connected in daisy-chain, (in the case of CH1 and CH10 are
used), the actuation of the function that brings the resume operation between ASC25s
becomes troublesome. Accordingly, in normal operation, we recommend to not use the
function. Nevertheless, for a special case (e.g., the system operation is required to continue
even under wire-breaking between ASC25s), the function may be actuated based on the
judgment during system design.
(2)
General precautions for the Active Star Coupler
•
Do not remove the unit cover.
•
On using the optical fiber cables, care should be paid not to contaminate the edge faces of
the optical connectors. Since the optical parts have finely finished structures, care should be
given not to apply shock and unnecessary force to the parts. For handling and cleaning of
optical parts, refer to the "Installation and wiring" of the instruction manual.
•
Optical connectors of ports not in operation shall be provided with respective covers.
The mark indicates "DANGER". The label is attached to the portions that may
induce injury.
The precautions on the places around the terminal block with the
mark are the
following.
•
The protective cover on the terminal block at front face of the unit has sharp corners. Special
care should be paid for handling the cover.
•
During power acceptance to the Active Star Coupler, skin contact to the terminals on the
terminal block may induce electrical shock. Therefore, the protective cover shall be firmly
attached. During power acceptance to the Active Star Coupler, do not touch the terminals.