3 sdram configuration register (sdcfg), Section 4.3 – Texas Instruments DM648 DSP User Manual
Page 38
www.ti.com
4.3
SDRAM Configuration Register (SDCFG)
DDR2 Memory Controller Registers
The SDRAM configuration register (SDCFG) contains fields that program the DDR2 memory controller to
meet the specification of the DDR2 memory. These fields configure the DDR2 memory controller to match
the data bus width, CAS latency, number of internal banks, and page size of the external DDR2 memory.
Bits 0-14 of the SDCFG register are only writeable when the TIMUNLOCK bit is set to 0 (unlocked). See
for more information on initializing the configuration registers of the DDR2 memory
controller. The SDCFG is shown in
and described in
Figure 22. SDRAM Configuration Register (SDCFG)
31
24
Reserved
R-0x0
23
22
19
18
17
16
BOOT_
Reserved
DDR_DRIVE
Reserved
UNLOCK
R/W-0
R/W-0xA
R-0
R-0x3
15
14
13
12
11
9
8
TIMUNLOCK
NM
Reserved
CL
Reserved
R/W-0
R/W-0
R-0x0
R/W-0x5
R-0x0
7
6
4
3
2
0
Reserved
IBANK
Reserved
PAGESIZE
R-0x0
R/W-0x2
R-0x0
R/W-0x0
LEGEND: R/W = Read/Write; R = Read only; -n = value after reset
Table 20. SDRAM Configuration Register (SDCFG) Field Descriptions
Bit
Field
Value
Description
31-24
Reserved
Reserved. Writes to this register must keep these bits at their default values.
23
BOOT_UNLOCK
Boot unlock bit. Controls write access to bits 16 through 22 of this register.
0
Writes to bits 22:16 of this register are not permitted
1
Writes to bits 22:16 of this register are allowed
22-19
Reserved
Reserved. Writes to this register must keep these bits at their default value.
18
DDR_DRIVE
DDR2 SDRAM drive strength. This bit is used to select the drive strength used by the DDR2
SDRAM. This bit is writeable only when BOOT_UNLOCK is unlocked (set to 1).
0
Normal drive strength
1
Weak (60%) drive strength
17-16
Reserved
Reserved. Writes to this register must keep these bits at their default value.
15
TIMUNLOCK
Timing unlock bit. Controls write access for the SDRAM Timing Register (SDTIM1) and SDRAM
Timing Register 2 (SDTIM2). A write to this bit will cause the DDR2 Memory Controller to start the
SDRAM initialization sequence.
0
Register fields in the SDTIM1 and SDTIM2 registers may not be changed.
1
Register fields in the SDTIM1 and SDTIM2 registers may be changed.
14
NM
DDR2 data bus width. A write to this bit will cause the DDR2 Memory Controller to start the SDRAM
initialization sequence.
0
32-bit bus width.
1
16-bit bus width
13-12
Reserved
Reserved. The reserved bit location is always read as 0. A value written to this field has no effect.
38
DSP DDR2 Memory Controller
SPRUEK5A – October 2007