Toshiba TEC EM1-31071GE - Manual (Page 66)

14-2
14. OPERATING PROCEDURES
14.1 WEIGHING OPERATION
14.1 WEIGHING OPERATION
Menu: REG., M. DOWN, or REWRAP
Mode: WEIGH
The weigh mode is used to weigh a commodity and to issue the label. The label contains data such as a
weigh, unit price (price per weight) and total price (calculated as a result of the weighing operation).
The following is a basic operation seen at the sales floor of a store or at a back room where different kinds
and weights of commodities are repacked. Pressing the VOID key subtracts the last entry from the
memory.
Example) When PLU #100 and an unit price of $8.00 are set in the speed key #12.
1
100 g 1/4 1/2
0 0
PLU
PRT
*
The label is issued.
VOID
LB
kg
12
Enter the PLU #.
Press:
Press the
speed key.
The unit of measure can be changed
for CA model only.
LB
↔
kg
Available only when the initial
setting # 5-6 is set to 1.
kg scale
lb scale
Place a commodity
on the platter.
(Ex. 1.000 lb.)
MANUAL: : AUTO
Press when canceling
the last sales.
WEIGHT UNIT PRICE TOTAL PRICE
1.000 8.00 8.00
Liquid Crystal Display T-BONE STEAK
REG
Remote Display
NET WT.
SELL BY
PACKED ON
PRICE lb
(Sample label)
NOTES: 1. Pressing a speed key to which no PLU data has been assigned will result in an error. In this case,
press the C key, then press a speed key to which PLU data has been assigned.
2. To change between AUTO and MANUAL, follow the procedure provided in section 14.9.
3. If a unit price exceeding 4 digits is obtained by multiplying by 2 or 4 (when pressing the
1/2 lb key or 1/4 lb key), the unit price will be 0.
4. 100 g key is available only when the scale is a kg scale or operated on kg base.
This key, however, has no function on the AU type.
5. When the 1/2 lb , 1/4 lb or 100 g key is pressed, the unit price will change on the display.
The 100 g key, however, has no function on the AU type.
6. When the “compulsory tare” is selected, a tare must be subtracted in a weighing operation, otherwise
an error message “TARE REQUIRED” will be displayed when the following operation has been done:
Manual mode: Pressing the PRT/* key
Auto mode: Placing a commodity on the platter.
Floating vendor mode: Pressing the Vendor key.
When a “TARE REQUIRED” is displayed, refer to Section 14.6 to follow the proper weighing
procedure.
TEC STORE
(TEL) 0123-45-6789