Toshiba RELIABILITY IN MOTION 1000 - Manual (Page 23)

XXII
12. The heat sink and other components may become extremely hot to the touch. Allow
the unit to cool before coming in contact with these items.
13. Warning signs should be placed on or near the load as a notification that the load is
being powered by the UPS.
14. Additional warnings and notifications shall be posted at the equipment installation
location as deemed required by Qualified Personnel.
While operating in the inverter mode, placing the breaker in the OFF position will
switch the UPS to the battery backup mode. The output of the UPS will continue
uninterrupted to the load. The unit must be in the bypass mode at the time that the
breaker is placed in the OFF position for the UPS to shutdown power to the load.
After an Emergency Power Off (EPO), do not reset the breaker until the UPS has been
fully discharged. The UPS could be damaged if the unit is not fully discharged before
the breaker is reset.
WARNING
CAUTION