Technicolor - Thomson DTH7500 - Manual (Page 22)

22
Recording functions
To watch TV Programmes
To take full advantage of the TV functions and TV program recording features, your DMR must be
used as if it were at the centre of your TV setup.The connection shown on page 4 will allow you
to do this. Consider your DMR as a television set without a screen and your TV set as a screen
only.The channels will therefore have to be selected from the DMR and its remote control
1. Turn on your television set.
2. Turn on your DMR using the STANDBY/ON key.The time displayed on your DMR is
replaced by the word MENU .
• After a few seconds the main menu of the player appears on the television screen.
• Channels function is already selected.
Note: turn off non used devices to avoid problems of selecting
sockets or other types.
If the main menu of the player is not displayed on the television
screen, check and/or select the Scart socket to which you
connected your DMR (see page 4 - AV1 selection). Generally the
selection is carried out using the
AV key on the television set
remote control.
3. Press the OK key of the remote control or one of the PR+/PR- , keys on the front panel.
• The images of the last watched channel appear.
• Encrusted within the image is information on the channel and programme.This disappears
after several seconds.
Note: when the information banner is displayed at the top of
the screen you have the possibility of choosing an audio channel
(if this is provided by the channel) using the
key on the
remote control.
To display information again, press the INFO key of the remote
control.
4. Change the channel with the PR+/PR- key or the remote control number keys.To select a
channel on a device connected to your DMRs use the AV key of the remote control or press
PR+/PR- several times.
DTH7500_en 4/07/03 16:55 Page 22