Toshiba XT JK Series - Manual (Page 3)

Toshiba's JKSSS4 series complies with EEMAC,
NEMA, UL and CSA standards and is available in
non-reversing and reversing, multi-speed, synchro-
nous and wound rotor configurations.
The JKSSS4 series is available in the following
enclosed ratings:
360 Amps Max.
2300-6900 Volts
Short Circuit & Withstand Capability
Approximate Maximum Horsepower Based on Continuous Current
SOLID STATE STARTER
JKSSS4+ Series
z Electronic Overload:
Retentive Thermal Memory
Dynamic Reset Memory
z Phase Imbalance/Single Phase
z Short Circuit
z Ground Fault - Optional
z RTD Temperature
z Phase Reversal/Phase Sequence
z Overcurrent
z Starts-per-Hour
z Shorted SCR
z Undercurrent/Loss of Load
z Starter Overtemperature
z Shorted SCR
z Undervoltage
z Overvoltage
Protective Features
Continuous Current
Enclosure Type
Max. Continuous Amps*
90" One-High Controller
Type 1 Ventilated 360A
Type 12 Ventilated w/
Fans & Type 12 Filters
310A
Type 1 Non-Ventilated 300A
Type 12 & 3R 300A
Interrupting
Capacity
(Symmetrical
Amperes)
Interrupting
Capacity
(Symmetrical
MVA)
Short Time
Capability
30 Seconds
(Amperes)
Short Time
Capability
1 Second
(Amperes)
Dielectric
Withstand
1 Minute
(kVAC)
Impulse
Voltage
Withstand
(kV)
50,000
@ 2.3 - 6.6 kV
200 @ 2.3 kV
350 @ 4.0 kV
400 @ 4.6 kV
570 @ 6.6 kV
2400 6000 18.2 60
2300V 4200V 6600V
0.8 PF 1.0 PF 0.8 PF 1.0 PF 0.8 PF 1.0 PF
360 1500 1750 1500 2500 3000 3000 4000 5000 4500
320 1250 1500 1250 2250 2500 2500 3500 4000 4000
300 1000 1250 1000 2000 2500 2250 3000 3500 3500
Synchronous
Motors
Induction
Motors
Enclosed
Maximum
Continuous
Current
(Amperes)
Maximum Horsepower at Utilization Voltage
Synchronous
Motors
Induction
Motors
Synchronous
Motors
Induction
Motors
If UL or CUL is required,
specify when ordering.
Consult Factory for
applicable models and
options.