Texas Instruments 4000M - Manual (Page 99)

Startup Error Messages
Diskette drive 0
V
failure
Diskette read
V
failure - press F1 to
retry boot
Fixed disk failure
V
V
Fixed disk read
V
failure - press F I to
retry boot
Invalid
V
Configuration
Information
V
Keyboard
V
clock/data line
V
failure
Keyboard stuck
V
key failure
V
Missing operating
V
system
V
Press Ctrl-Alt-Esc to ensure that the drive type is set
correctly in Setup (should be 3.5 inch, 1.44 MB).
Floppy defective or unformatted; insert a different
floppy and press F1.
Turn the computer off-, wait several seconds; then
turn the computer on again.
Press Ctrl-Alt-Esc to ensure hard disk type is correct
in Setup (should be the default for the internal hard
disk).
Press Ctrl-Alt-Esc to ensure hard disk type is correct
in Setup (should be the default for the internal hard
disk).
Defaults in Setup may have changed. Enter Setup
and press Esc-F5 to reset defaults. Then press Esc-
F4 to save and reboot.
Battery that maintains configuration has failed; follow
procedure in this chapter to restore configuration.
Ensure external keyboard connected correctly.
Replace external keyboard.
Press jammed key to unstick it
Ensure no keys pressed during computer startup.
Press Ctrl-Alt-Esc to ensure the hard disk is defined
correctly in Setup.
Reboot using the System Files Recovery diskette.
6-4