Texas Instruments TM5000 Series - Manual (Page 86)

Using a Password
You may set a password from the Setup Menu in
DOS. To set a password, complete the following
steps:
1. Enter the Setup menu by pressing Ctrl-Alt-Esc .
2. From the Setup Menu, press Tab until you reach
the Password field.
3. Press the left or right arrow key.
A Modify Password box appears and prompts
you to type in a new password.
4. Enter a new password of up to seven characters
and press
Enter .
You are asked to verify the password by
retyping it.
5. Retype the password and press Enter .
The password is set to Enabled and you will be
prompted for the password every time you
reboot the system
. You have three tries to
enter the correct password on powerup before
the system halts and you have to shut down.
6. To save your changes, press Esc-F4 .
Using a Password
5-9