Asus P4-P5N9300 - Manual (Page 59)

ASUS P2-P5N9300/P4-P5N9300 4-17
4.3.3 SATA 1-2
While entering Setup, the BIOS automatically detects the presence of SATA
devices. There is a separate submenu for each SATA device. Select a device item
then press to display the SATA device information.
The BIOS automatically detects the values opposite the dimmed items
(Capacity, Cylinder, Head, Sector, and Transfer Mode). These values are not
user-configurable. These items show 0 if no SATA device is installed in the system.
PIO Mode [Auto]
Selects the PIO mode. Configuration options: [Auto] [Mode 0] [Mode 1] [Mode 2]
[Mode 3] [Mode 4]
UDMA Mode [Auto]
Selects the UDMA mode. Configuration options: [Disabled] [Auto]
SATA 1 [Auto]
Allows you to enable or disable SATA 1. Configuration options: [None] [Auto]
[Manual]
Access Mode [Auto]
Sets the sector addressing mode. Configuration options: [CHS] [LBA] [Large]
[Auto]
Before configuring a hard disk drive, ensure that you have the correct
configuration information supplied by the drive manufacturer. Incorrect settings
may cause the system to fail to recognize the installed hard disk.
Select Menu
Item Specific Help
Phoenix-AwardBIOS CMOS Setup Utility
Main
F1:Help ↑↓ : Select Item -/+: Change Value F5: Setup Defaults
ESC: Exit →←: Select Menu Enter: Select SubMenu F10: Save and Exit
SATA 1
PIO Mode [Auto]
UDMA Mode [Auto]
SATA 1 [Auto]
Access Mode [Auto]
Capacity 0 MB
Cylinder 0
Head 0
Sector 0
Transfer Mode None