Toshiba 72HM195 - Manual (Page 8)

8 Copyright © 2005 TOSHIBA CORPORATION. All rights reserved.
(E) 56/62/72HM195
1. Carefully read the important safety, installation, care,
and service information on pages 2–5. Keep this
manual for future reference.
2. Observe the following when choosing a location for
the TV:
• Place the TV on the floor or on the optional TV stand listed in
the “Specifications” section (page 106).
Overview of steps for installing, setting up, and using your new TV
Follow these steps to set up your TV and begin using its many exciting features.
Chapter 1: Introduction
Note: If you sell or transfer this television to a third party, be sure
to reset the PIN code as described on page 93 under the heading,
“If you cannot remember your PIN code.”
• Place the TV in a location where light does not reflect on the
screen.
• Place the TV far enough from walls and other objects to allow
proper ventilation. Inadequate ventilation may cause
overheating, which will damage the TV. THIS TYPE OF
DAMAGE IS NOT COVERED UNDER THE TOSHIBA
WARRANTY.
• Read “Installation” on pages 3–4.
• Read “Important notes about your DLP™ TV” on page 5.
3. Do not plug in any power cords until AFTER you have
connected all cables and devices to your TV.
4. BEFORE connecting cables or devices to the TV, learn
the functions of the TV’s connections and controls (pages 9
and 10).
5. Connect your other electronic device(s) to the TV
(pages 12–25).
6. Connect the G-LINK™ cable (either one of the enclosed IR
blaster cables) from your VCR and/or Cable box (if applicable) to
the G-LINK™ terminal so you can use the TV Guide On Screen™
features (applies to VCRs and cable boxes only). See page 25.
7. Install the batteries in the remote control (page 28).
8. See “Learning about the remote control” (page 26) for
an overview of the buttons on the remote control.
9. Program the remote control to operate your other
device(s) (pages 28–34).
10. AFTER connecting all cables and devices, plug in the
power cords for your TV and other devices.
11. After you plug in the TV power cord, the yellow LED (on
the TV front) will blink while the TV is booting until the remote
control is usable. When the yellow LED stops blinking, press
POWER to turn on the TV.
See “LED indications” on page 99.
12. See “Menu layout and navigation” for a quick overview
of navigating the TV’s menu system (pages 35–36).
13. See Chapter 5 for details on setting up the TV Guide
On Screen™ system (if available in your area).
14. See Chapter 7 for details on using the TV Guide
On Screen™ program guide (if available in your area).
15. Program channels into the TV’s channel memory
(page 42).
16. Set up the TheaterNet™ on-screen device control
feature (if applicable to your particular home theater system
components) (page 45).
17. For details on using the memory card JPEG picture
viewer and MP3 audio player, see page 87.
18. For details on using the TV’s features, see Chapter 8.
19. For help, refer to the Troubleshooting Guide (Chapter
10).
20. For technical specifications and warranty information,
see Chapter 11.
21. Enjoy your new TV!
NOTICE OF POSSIBLE TV STAND INSTABILITY
DANGER: RISK OF SERIOUS PERSONAL INJURY
OR DEATH! Use this TV only with the TOSHIBA TV
stand listed in the “Specifications” section (page 106). Use with other
stands may result in instability, causing possible injury or death.
#01E_007-008_566272HM195 7/28/05, 4:08 PM 8
Black