Toshiba 72HM195 - Manual (Page 79)

79
Chapter 8: Using the TV’s features
Copyright © 2005 TOSHIBA CORPORATION. All rights reserved.
(E) 56/62/72HM195
Adjusting the picture
Selecting the picture mode
You can select your desired picture settings from four picture
modes, as described below.
To select the picture mode:
Press PIC MODE on the remote control.
The following popup menu appears on-
screen.
Picture Settings Mode: Standard
Mode Standard
Repeatedly press PIC MODE to cycle
among the modes. Or use
x or • to
select the modes.
To select the picture mode using the menu system:
1. Press MENU and open the Video menu.
2. Highlight Picture Settings and press ENTER.
Picture Settings
Advanced Picture Settings
Theater Settings
Video
3. In the Mode field, select the mode you prefer.
Done
Picture Settings
Mode Sports
Contrast 100
Brightness
Reset
50
50
0
50
ANT 1
Color
Tint
Sharpness
Picture Settings Mode: Standard
Mode Standard
4. To save the new settings, highlight Done and press
ENTER. To revert to the factory defaults, highlight Reset
and press ENTER.
Note:
• The picture mode you selected is for the current input
selection only (ANT 1 in the example above). You can select
a different picture mode for each input selection.
• If you select one of the factory-set picture modes (Sports,
Standard, or Movie) and then change a picture quality setting
(for example, increase the contrast or change the color
temperature), the picture mode automatically changes to
Preference in the Picture Settings menu.
Adjusting the picture quality
You can adjust the picture quality (contrast, brightness, color,
tint, and sharpness) to your personal preferences.
To adjust the picture quality:
1. Press MENU and open the Video menu.
2. Highlight Picture Settings and press ENTER.
Picture Settings
Advanced Picture Settings
Theater Settings
Video
3. Press y or z to select the picture quality you want to adjust
(Contrast, Brightness, Color, Tint, or Sharpness), and then
x and • to adjust the setting, as described in the table
above.
Done
Picture Settings
Mode Sports
Contrast 100
Brightness
Reset
50
50
0
50
ANT 1
Color
Tint
Sharpness
Picture Settings Mode: Preference
Contrast 70
4. To save the new settings, highlight Done and press
ENTER. To revert to the factory defaults, highlight Reset
and press ENTER.
The picture qualities you adjusted are automatically saved in the
Preference mode (see “Selecting the picture mode,” above left).
Selection x Pressing •
contrast lower higher
brightness darker lighter
color paler deeper
tint reddish greenish
sharpness softer sharper
Mode Picture Quality
Sports Bright and dynamic picture (factory setting)
Standard Standard picture settings (factory setting)
Movie Lower contrast for darkened room (factory setting)
Preference Your personal preferences
PIC
MODE
#01E_079-086_566272HM195 7/28/05, 4:49 PM 79
Black