beautypg.com

79, in th – Toshiba 32TL515U User Manual

Page 79

background image

79

Chapter 9: Troubleshooting

– Connect with LAN cables, if possible, and check

connection stability.

– Repeat the wireless network setup procedure and check

connection stability.

The DMS name is not displayed

• The LAN cables, if used, are not connected properly

(

- p. 23).

• The WLAN, if used, is not configured properly.
• The network setup on the Server is incorrect. Make sure both

the DMS and TV are using the same network type (DHCP/
manual) and have compatible network settings.

• Too many DMSs are connected. You cannot connect more

than 32 sharing devices at one time.

• The DMS is not turned ON.
• The “server” is not a DMS device.
• Check the firewall and streaming settings on the DMS.

Wireless network problems

• Check that the router/AP (Access point) power is ON.
• After starting wireless network setup, confirm that the

network is configured properly by performing the network
connection test (

- p. 66).

• Check the router/AP’s connection status (- p. 64).
• If the router/AP does not support PBC or WPS, Easy Setup

(PBC) will not work even if the push-button is pressed.

• If the available router/AP list is not displayed in Easy Setup

(PBC) or Assisted Setup, the power of the router/AP may be
OFF. Check that it is ON, and then try re-starting the scan for
available routers/APs.

• Refer to the router/AP’s instruction manual.

NET TV or Widget problems

• If the date and time display on the NET TV menu is wrong,

turn off the TV, and turn it on again.

• NET TV or Widgets may not be immediately available after

turning the TV on while the system is booting.

• When NET TV or Widgets doesn't operate properly (a

message window is displayed when

or

is

pressed), do one of the following:
1) Turn off your TV. After 30 seconds, turn it on.
2) Turn off the TV and unplug the power cord. After 1 minute,
plug the power cord in and turn on the TV.
3) Perform the Reset Yahoo! TV Widgets procedure
(

-p. 70).

4) Perform the Reset Factory Defaults procedure (

- p. 51).

• Content delivered by NET TV or Widgets are the responsibility

of the Content Service Provider. Contact the Service Provider
to discuss any content issues.

Media Player problems

• Ensure that the devices (Display and Server) are connected

correctly.

• Incorrect behavior may occur when using a USB HUB

connection.

• Photo files that were processed and edited using the PC’s

application software may not be viewable.

• When viewing content that supports two or more formats the

display may select one format automatically.

• Copyright protected content stored on the DMS may not be

playable on the display.

• Content playback stability may be affected by heavy network

traffic.

• Content originally recorded on a PC may not play correctly.
• Set the media sharing of the DMS correctly, according to the

DMS instruction manual.

• Confirm that the contents of either the DMS or the USB

storage device are in formats that are supported by this TV
(

- p. 73, 74, or 75).

• Depending on the DMS, access may be limited by the MAC

address. Set the server according to the DMS’s instruction
manual. This TV’s MAC Address can be confirmed in the
Network Setup portion of the User Menu (

- p. 65).

For DLNA CERTIFIED

Player

• Depending on the DMS, it may take time to display the list.