Trimble Outdoors AgGPS 252 - Manual (Page 66)

B Third-Party Interface Requirements
6 0 AgGPS 252 Receiver User Guide
VCD (Vision
Display
Controller) Rockwell NMEA GGA, GLL,
VTG, ZDA 4800 8-N-1 1 Hz 50166, or
30945 plus
50581
Swath XL Midtech NMEA GGA 19200 8-N-1 5 Hz 50166, or
30945 plus
50581
Caterpillar
Cebis Yield
Monitor Claus NMEA GGA 4800 or
9600 8-N-1 1 Hz 50166, or
30945 plus
50581
AGCO
FieIdStar
Yield
Monitor
4
AGCO NMEA GGA, VTG,
GSV, GSA 4800 8-N-1 1 Hz 39903 plus
50581
1 P/N 39903 replaced old Ag Leader cable P/N 30660.
2 Connect to Aux port.
3 Older GreenStars with version 5.3P mapping processor software require 9600 baud. Older GreenStars
with version 5.3R mapping processor software require 4800 baud.
4 AGCO unit requires a null modem RS-232 connection. Ag Leader cable P/N 39903 is wired correctly for
connection.
Table B.2 Third-party hardware interface requirements (continued)
Hardware Company Protocol NMEA
messages Baud Other Pos
rate Cable P/N
Ag252_100B_UserGuide_ENG.book Page 60 Thursday, July 28, 2005 4:06 PM