Connectors and pinouts, Port a – Trimble Outdoors AgGPS 252 User Manual
Page 30
3 Installing the Receiver
2 4 AgGPS 252 Receiver User Guide
3.4
Connectors and Pinouts
Use the following pinout information if you need to wire a cable for use
with the AgGPS 252 receiver.
Figure 3.2
AgGPS 252 receiver port pinout
34.1
Port A
Port A on the receiver has a 12-pin Deutsch DTM connector. For cables,
use the mating connector, Deutsch part number DTM06-12SA.
Viewed from outside the receiver, the Port A connector is on the left. It
is the port that is typically used to connect to an Autopilot system.
Table 3.3
Port A pinout
Pin
Name/Function
Comments
1
CAN A High I/O
2
Port 1 RS232 Tx OUT
When held to ground during power up,
puts unit into Monitor mode
3
Port 1 RS232 Rx IN
4
PPS OUT
2
1
3
4
5
6
7
8
9
10
11
12
Ag252_100B_UserGuide_ENG.book Page 24 Thursday, July 28, 2005 4:06 PM