Trimble Outdoors AgGPS 252 User Manual
Page 13
AgGPS 252 Receiver User Guide 7
Overview 2
On the Trimble website ((, refer to the
document called NMEA-0183 Messages Guide for AgGPS
Receivers.
•
1 PPS output
To synchronize timing between external instruments and the
internal clock in the receiver, the connection port outputs a
strobe signal at 1 PPS (pulse per second). To output this signal,
the receiver must be tracking satellites and computing GPS
positions.
•
J1939 (CAN) bus
Both connection ports on the receiver support the J1939
Controller Area Network (CAN) bus protocol. This protocol
standardizes the way multiple microprocessor-based electronic
control units (ECUs) communicate with each other over the
same pair of wires. It is used in off-highway machines, such as
those used in agriculture, construction, and forestry.
For more information, go to the Society of Automotive Engineers
(SAE) International website
•
ISO 11783 messages
Both CAN ports support some ISO 11783 messages.
Position output format
The AgGPS receiver outputs positions in Degrees, Minutes, and
Decimal Minutes (DDD°MM.m'). This is the NMEA standard format
and is commonly used worldwide for data transfer between electronic
equipment.
Ag252_100B_UserGuide_ENG.book Page 7 Thursday, July 28, 2005 4:06 PM