Toshiba 23HLV84 - Manual (Page 23)

23
DVD Playback
Using the
TV/DVD
’s Features
Setting up
your TV/DVD
Connecting
your TV/DVD
Introduction
Appendix
POWER
1 2 3
4 5 6
7 8 9 0
TV(DVD) VCR CABLE
TV/DVD
100
CH +
CH –
EXIT/
CANCEL INPUT PIC SIZE
MUTE
JUMP CH RTN/ZOOM SKIP
REW/SEARCH FF/SEARCH PLAY
SUBTITLE AUDIO
RETURN ANGLE REPEAT A-B
ENTER
VOL
CODE
VOL
+ –
SLEEP
PLAY MODE
MENU/
SETUP
RECALL/
DISPLAY
TOP MENU DVD MENU
Programming the remote control for use with a VCR,
or cable TV converter
This remote control is pre-programmed to operate Toshiba VCRs. To
control VCRs, or cable converters other than Toshiba models, you
must follow the steps below to program your remote control.
1. While holding down the CODE button, press the button for the
device you want to control (VCR, or CABLE).
2. Enter the 2-digit code listed on page 24 using the Number buttons
(0-9) within 10 seconds.
3. Point the remote control at the VCR, or converter and press
POWER to test the code.
• If the VCR, converter turns on, you have entered the right code.
• If the VCR, or converter does not respond to the remote control,
you may have entered the wrong code. Repeat steps 1–2 with
another code.
For future reference, write down the codes you used:
VCR code
Cable TV converter code
Notes:
• When shipped from the factory, the remote
control is set to operate your TV/DVD.
• If you do not enter the code within 10
seconds from step 1 or if you enter a code
not listed below, this operation is canceled.
• Each time you replace the batteries, you
must reprogram the remote control.
• Some newer VCRs are capable of working
on either of two remote codes. These VCRs
have a switch labeled “VCR1/VCR2.”
If your VCR has this kind of switch and
does not respond to any of the codes for
your VCR, set the switch to the other
position (VCR1 or VCR2) and reprogram
the remote control.
Code
VCR
Cable
Setting up
your TV/DVD
J5P00101A(E)P22-28 8/12/04, 11:32 AM 23