TANDBERG Codec C90 D14128.02 - Manual (Page 75)

D14128.02—NOVEMBER 2008 75
Codec C90 System Integrator Guide
Contents Introduction Getting Started Interfaces About the API xConfiguration xCommand xStatus Cameras Appendices Contact us xCommand
xCommand HttpFeedback Deregister
Command used to deregister XML eedback over HTTP(S).
Required parameters with ( r ):
FeedbackSlot: <1..3>
Example:
xCommand HttpFeedback Deregister FeedbackSlot:1
OK
*r FeedbackDeregisterResult (status=OK):
FeedbackSlot: 1
*r/end
xCommand Key Click
Command used to emulate pressing a key on the remote control for a short while. This command needs no
release command.
Required parameters with ( r ):
Key( r ): <0/1/2/3/4/5/6/7/8/9/C/Call/Disconnect/Down/F1/F2/F3/F4/F5/Grab/Home/
Layout/Left/Mute/MuteMic/Ok/PhoneBook/Presentation/Right/Selfview/
Square/SrcAux/SrcCamera/SrcDocCam/SrcPc/SrcVcr/Star/Up/VolumeDown/
VolumeUp/ZoomIn/ZoomOut>
Duration: <0..65534>
Example:
To be described.
xCommand Key Press
Command used to emulate pressing a key on the remote control without releasing it. The Key Press
command should be followed by a Key Release command to emulate releasing the key.
Required parameters with ( r ):
Key( r ): <0/1/2/3/4/5/6/7/8/9/C/Call/Disconnect/Down/F1/F2/F3/F4/F5/Grab/Home/
Layout/Left/Mute/MuteMic/Ok/PhoneBook/Presentation/Right/Selfview/
Square/SrcAux/SrcCamera/SrcDocCam/SrcPc/SrcVcr/Star/Up/VolumeDown/
VolumeUp/ZoomIn/ZoomOut>
Example:
xCommand Key Click Key:Home
*r KeyClickResult (status=OK):
*r/end
OK
The Key commands