TC Electronic NM-1 Nova Modulator - Manual (Page 28)

Preset and Bank mode
The NOVA Modulator has two ways of organizing your
presets. Depending on your application you may
choose either.
Preset mode
This is the default mode in which you can store and
recall up to nine presets. In this mode you can
alternate between the Preset and “Manual”, where the
positions of the knobs always apply.
Selecting Preset mode:
•
Enter Calibration mode by holding the MANUAL
button for one second. The PRESET button should
now be steadily lit – if it is flashing; press the
PRESET button once.
• Exit Calibration mode by pressing any other button
than PRESET.
Accessing a Preset:
•
Press PRESET to access a preset. You can store
up to nine presets. Each preset holds the
parameter settings for both Engines A and B.
You can not toggle between Engines A and B as
both Engines are always part of a preset,
whether they are active or not.
Selecting presets can be done in a couple of ways:
•
Press the PRESET button several times to step
through the presets.
• Press the TAP/TEMPO switch once and
immediately after that the ON/OFF button multiple
times.
In Preset mode, you can switch between the current
preset and the manual settings.
Alternating between the two settings can be done in
two ways:
• Press the MANUAL button to access Manual
mode. In this mode, the position of the knobs
always apply.
• Alternate between Manual mode and Preset mode
by holding the ON/OFF button for approximately
one second and then releasing.
PRESETS
28