TC Electronic NM-1 Nova Modulator - Manual (Page 10)

10
OVERVIEW
This section describes in short the functions of the
knobs and buttons on the NOVA Modulator. For
detailed explanations of the various parameters, please
refer to the manual section describing the effects.
Connections
1 – Power
The NOVA Modulator requires 12V DC 300 mA. Use
the power supply provided in the product box or a
power supply with similar specifications.
2 – Inputs
These are ¼" mono jack connectors for signal input.
NOVA Modulator will sense if a signal source is
connected to both inputs and treat these signals as
one stereo source. If you connect a mono source only,
ALWAYS use the left input!
3 – Outputs
These are ¼" mono jack connectors which carry the
signals from channels A and B.
Controls
4 – ON/OFF Switch
The ON/OFF switch has several functions.
•
Press the ON/OFF switch once to bypass or
activate the pedal.
• Press and hold the ON/OFF switch for
approximately 0.5 seconds to alternate between
Manual mode and Preset mode.
5 – TAP TEMPO Switch
Tap this switch rhythmically to enter the global tempo.
Typically, you will tap quarter notes.
Example: Preset selection using the ON/OFF and the
TAP TEMPO switches
When you are in Preset mode, you can step through
presets by pressing the PRESET button repeatedly.
The same function can be invoked by first pressing the
TAP/TEMPO switch once and immediately thereafter
pressing the ON/OFF switch multiple times.