Toshiba TDP-MT400 - Manual (Page 15)

29
Operations
28
English Français Español Deutsch Italiano Português Svenska
■ The image adjustment menu
Use this menu to adjust image-related items.
Items that can be adjusted are marked with “Yes”, and those that cannot are marked with “No”.
Item Description Computer Y/P B /P R
Video
DVI
S-video
Contrast Adjust the image contrast. Yes Yes Yes Yes
Lower Higher
Brightness Adjust the brightness of the image. Yes Yes Yes Yes
Darker Brighter
Color Adjust the color of the image. No Yes Yes No
Lighter Deeper
Tint *1 Adjust the tint of the image color. No No Yes No
Reddish Greenish
Sharpness Adjust the sharpness of the image. No Yes Yes No
Softer Sharper
Noise Set the function to reduce screen noise. No Yes Yes No
reduction On (Enable) Off (Disable)
Picture Press . Toggle the picture mode with Yes Yes Yes Yes
mode / .
Dynamic/Standard/Theater
R-level Adjust red of the image color. Yes Yes Yes Yes
Less red More red
G-level Adjust green of the image color. Yes Yes Yes Yes
Less green More green
B-level Adjust blue of the image color. Yes Yes Yes Yes
Less blue More blue
NTSC mode *1 Set the black level with / button. No No Yes No
US: NTSC (US) mode
Japan: NTSC (JAPAN) mode
*1: [Tint] and [NTSC mode] can be displayed and adjusted only when the video signal is set to
[NTSC] and [NTSC4.43]. (NTSC mode is set to JAPAN when the language is set to Japanese. It is
set to US for other languages.)
You can call up on-screen menus, and conduct a number of adjustments and settings using
the operation buttons
p.16 on the control panel (main unit side) and remote control.
■ How to use the menus
The menu shown below is for operation instructions purposes and might differ from the
actual display.
Using the menus
Note
• Menu adjustments and settings are saved when the power is turned off via the ON/
STANDBY button. If the power cable is disconnected before this, or the power goes out,
then the data will not be saved.
Display the Setting display menu
The menu disappears.
1. Press the MENU button
2. Select a Category
3. Adjustments & Settings
5. End
Press the MENU
button
Select a category by using .
There are following four
categories:
Displays the current
adjustments and settings of
selected category.
Item shown with gray cannot
be adjusted with the current
input source.
p.29 Image adjustment menu
p.30 Display setting menu
Default setting menu p.31
Status display menu p.32
The figure shows displays given for operation instructions purposes. As the display
may differ depending on the item, use the following pages as a reference.
Item
Adjustment/Setting Value
These marks signify the
items can be adjusted/set
by using .
These marks signify the items can
be selected from the list by using
.
After an item is selected, apply it
by pressing .
Press to open the menu.
This mark signfy that
there are options.
Press to display a
list of options.
4. Back
Return button