Toshiba TDP-MT400 - Manual (Page 11)

21 20
Operations
English Français Español Deutsch Italiano Português Svenska
■ Turning the power on
1 Turn on the main power switch
The ON indicator will change to
orange, indicating standby mode.
• After the main power switch is turned
on, the inner cooling fan starts
cooling.
2 Press the ON/STANDBY
button.
The power turns on, and the following
3 green indicators light: ON, LAMP,
and FAN. After a moment, the start-up
screen appears.
(Orange)
p.43
Before connection
• Read the owner’s manual of the device you are connecting to the projector.
• Some types of computer cannot be used or connected to this projector.
Check for an RGB output terminal, supported signal p.39 , etc.
• Turn off the power of both devices before connecting.
• The figure below is a sample connection. This does not mean that all of these devices
can or must be connected simultaneously. (Dotted lines mean items can be exchanged.)
Notes
• If you want to feed the digital RGB signal, separately available DVI cable is needed.
• If you are using the digital RGB signal for input to this unit, some computer models or a
certain type of DVI cable may cause on rare occasions noise on the screen. If such is a
case, decrease your computer’s refresh rate or the resolution. It is also recommended to
use a DVI cable in 2 m or less in length.
Connection
Computer (for control)
VCR, etc
Video recorder,
DVD player, etc.
To RS-232C
terminal
Control cable
To video
output
Video cable (supplied)
To S-Video
output
S-Video cable
(supplied)
RGB component video cable
(not supplied)
To Y/C
B /C R output
Green (Y)/Blue (C B )/Red (C R )
DVI cable
(not supplied)
To RGB output
Computer
DVD video recorder, etc.
Computer
RGB cable
(not supplied)
To DVI output
■ Connecting the power cord
1 Insert the power cord connector into the
AC IN socket of the projector.
2 Insert the power cord plug into a wall or
other power outlet.
Start-up screen Control panel
Remote
Control
Power cord connector
(Supplied)
CAUTION
• Do not look into the lens while the lamp is on. The strong light from the lamp may cause
damage to your eyes or sight.
• Do not block the air intake or exhaust. Doing so could cause a fire due to internal overheating.
• Do not place your hands, face, or other objects near the air exhaust. Doing so could cause
burns, deform/break the object.
■ Removing the lens cover
Be sure to remove the lens cover when the power is
turned on. If it is left on, it could become deformed due
to heat.
Turning the power on and off