Thermador 9000039271 - Manual (Page 8)

8
Removing the Toe Panel
DWHD94BF Regular Toe Panel
The toe panel is loosely attached with tape. Remove
the tape and pull the toe panel away from the
dishwasher. Set the toe panel aside. It will be
reinstalled later.
DWHD94BP and DWHD94BS Base and Toe
Panel
The base and toe panel are in place on the
dishwasher, but are not attached. Remove the toe
panel first, as shown in Figure 12, letter A, then
remove the base, as shown in Figure 12, letter B.
Figure 12
A
B
Figure 14
D
X
Junction Box
Figure 13
Junction
Box Cover
DISHWASHER PREPARATION (continued)
Installing the 90° Elbow Fitting
NOTE: The 90° elbow fitting is not supplied with the
dishwasher, and must be purchased separately. If
the dishwasher’s hot water supply line is to be
copper tubing, make certain the elbow has a
compression fitting.
Apply Teflon tape or other pipe sealant when
required.
Orient the hot water supply connection leg of the
elbow toward the channel opening in the dishwasher
base.
Junction Box Preparation
1. Remove junction box cover, Figure 13, by lifting
the junction box cover up and off.
2. Remove the strain relief plate by removing the
screw at the back of the junction box, as shown in
Figure 14, letter D and sliding the strain relief plate
out.
3. Set the junction box cover, strain relief plate, and
screw aside. They will be re-installed later.