Thermador 9000039271 - Manual (Page 15)

15
DWHD94BP and DWHD94BS Base and Toe Panel
Installation
1. Place the Base Part under and up the front bottom
panel of the dishwasher, as shown in Figure 29.
2. Insert the Base Part screws (Figure 1, letter O)
into the Base Part, as shown in Figure 29, letter B.
Tighten the Base Part Screws.
3. Place the Cotton Insulation Strip (Figure 1, letter
C) under the unit, between the bottom of the Base
Part and the floor, as shown in Figure 29, letter C.
4. Place the toe panel over the Cotton Insulation
Strip, and use the toe panel screws (Figure 1,
letter N) to secure the toe panel in place, as
shown in Figure 29, letter D.
Figure 29
A
B
D
C
BASE AND TOE PANEL (Continued)
FINAL INSTRUCTIONS
1. Energize the dishwasher power supply circuit.
2. Consult the Dishwasher Use and Care Manual,
and run the dishwasher through one complete
cycle.
If the dishwasher does not operate properly, refer to
the Self-Help section of the Use and Care Manual. If
the dishwasher still does not operate properly, refer
to the Customer Service Section of the Use and
Care Manual.