Thermador 9000039271 - Manual (Page 10)

10
1. Straighten and position the hot water supply line
and the electrical supply cable as shown in Figure
16 so that they will align with their channels under
the dishwasher base.
2. Position the dishwasher close enough to the
enclosure so that you can run the dishwasher
drain hose to the under sink drain connection.
Make certain that the hot water supply line and the
electrical supply cable are in their channels under
the dishwasher base, as shown in Figure 17,
letter A.
3. Place the dishwasher directly in front of the
enclosure.
4. Perform a level check as shown in Figure 17.
Adjust the rear leveler by turning the center screw
at the front of the dishwasher, as shown in Figure
18, letter B. Turning the screw clockwise raises
the rear of the dishwasher. Adjust the front
levelers by turning them with a screwdriver, as
shown in Figure 18, letter C. Turning the levelers
to the right raises the dishwasher. If additional
height is needed, shims may be added under the
leveler feet.
5. Push the dishwasher into the enclosure.
SECURING THE
DISHWASHER
Drive the mounting screws through the holes in the
mounting brackets, as shown in Figure 19, letter A
for Top Mount, or as shown in Figure 19, letter B for
Side mount.
Figure 19
A
B
Figure 18
B
C
A
Figure 16
21"
(533mm)
14"
(355mm)
Figure 17
PLACING THE DISHWASHER