Thermador 9000039271 - Manual (Page 13)

13
WARNING: ELECTRICAL SHOCK
HAZARD - Working on an energized circuit
could result in serious injury or death. Only
qualified electricians
should perform electrical work. Do not
attempt any work on the dishwasher electric
supply circuit until you are certain the circuit
is de-energized.
WARNING: FIRE HAZARD -
Improper electrical work can cause fire. Only
qualified electricians should perform electri-
cal work.
Grounding Instructions
The dishwasher must be properly grounded before
operating. This appliance must be connected to a
grounded metal permanent wiring system, or an
equipment grounding conductor must be run with the
circuit conductors and connected to the equipment
grounding terminal or lead on the dishwasher. Make
sure that the dishwasher is connected to a suitable
ground in compliance with all local codes or, in the
absence of a local code, with the NATIONAL ELEC-
TRICAL CODE in the United States or the
CANADIAN ELECTRIC CODE C22.1-latest edition in
Canada as well as any provincial/state or municipal
or local codes that apply.
1. Retrieve the strain relief plate, and install a strain
relief (not supplied) into the opening on the strain
relief plate. NOTE: Orient the strain relief as
shown in Figure 24.
2. Pass the electrical supply cable through the strain
relief, as shown in Figure 25. Leave 3 - 4 inches of
insulated wire extending through the strain relief
plate.
3. Tighten the strain relief screws.
4. Slide the strain relief plate into the junction box,
and secure it to the junction box with the supplied
screw.
(Continued on next page)
Figure 25
Strain Relief Plate
Figure 24
Strain Relief
(not supplied)
Strain
Relief
Plate
ELECTRICAL CONNECTION