Toshiba P503DL User Manual

Page 27

This remote control is compatible for most of Toshiba data-wall display cube.
The GUI of cube commander is also similar layout of the push buttons so that once the position of
these key pads are getting familiar, both can be used without any difficulty.
Difference between this remote control and software is, the ID number access, this is caused by the
command generation CPU, in a PC which the software is installed or use the CPU in the cube.

stand-by mode

ßà normal mode ßà adjust mode ßà special mode

Power Power Cut -off 1: Auto-Adj on-off
Digital Drive 7: Picture in Picture
Video1 Gain 8, A, B, C: OSD color
RGB1 Off-set 9: Power Delay time
ID mode RGB2 Contrast D: Firmware Version
ID.ALL White Balance Brightness E: Lamp Timer History
ID.SEL Adjust Color F: Current Lamp timer
ID.SET Call Tint
ID.CLR STD Sharpness
Adjust * MODE (0-9) Phase

ßà service mode

(Mag. Memory) Clock 0:
Capture 1: OSD Mute
Magnification 2: Screen mode Lock
Layout 4: Picture smoothing filter
Position C:
Test pattern
Mode
Flip
Call

7: Color Mix (color coordinate) 4=R, 5=G, 6=B

ADJUSTMENT

3-1. Input Signal selection

Sources are selected by pressing the relevant source button: RGB1 RGB2 or VIDEO.
To select and display video picture, the video input adaptor need to be installed.
The screen will mute for approximately 5-7 seconds following source selection.
Source sele ction is basically possible in Normal Mode.

This chart is indicating the
functions and also which button
can be selected.

* MODE button makes to recall
Magnification memorized at
0-9 memory positions (ref P36)