W7 asd direct access/communication numbers, W7 asd, Direct access/communication numbers on pg. 46 – Toshiba W7 User Manual
Page 52: Parameter name no. parameter name no

46
W7 ASD Installation and Operation Manual
W7 ASD Direct Access/Communication Numbers
The W7 ASD has the ability to allow the user direct access to the motor control functions. The functions
listed below have an associated Parameter Number which accesses its setting. There are three ways in
which the motor-control parameters may be accessed for modification: Program
⇒
applicable menu path,
Program
⇒ Direct Access ⇒ applicable parameter number, or via Communications (see the 7-Series
Serial Communications User Manual for further information on communications protocol).
Once
accessed, the parameter may be viewed or changed.
The Program mode allows the user to develop
an application-specific motor control profile. Motor
control functions may be set to accommodate specific power and timing requirements for a given
application. The configurable parameters of the Program mode that have user-accessible Parameter
Numbers are listed and described below.
Note: The setup procedures included within this section may require a Reset before performing the
procedure. Application-specific settings may then be performed. The pre-Reset conditions may be
saved (see
).
Table 5. W7 ASD Direct Access/Communication Numbers.
Parameter Name
No.
Parameter Name
No.
0003
0021
0004
0022
0005
0023
0006
0024
0007
Low Speed Signal Output Frequency
0100
0101
0102
0103
(F and R On)
0105
0106
Assignment
0110
Assignment
0111
Assignment
0112
Assignment
0113
0008
Assignment
0114
0009
Assignment
0115
0010
Assignment
0116
0011
Assignment
0117
0012
Assignment
0118
0013
Assignment
0119
0014
Assignment
0120
0015
Assignment
0121
0016
Assignment
0122
0017
Assignment
0123
0018
Assignment
0124
0019
Assignment
0125
0020
Assignment
0126