Electrolux ECG6600 - Manual (Page 134)

g
134
0 Before starting the descaling pro-
gramme, clean the brewing unit (see
„Cleaning the brewing unit“ page 132).
0 Press the "MENU" button (Figure5). The
menu option «CHOOSE LAN-
GUAGE» appears.
0 Press the scrolling buttons "<" or ">"
(Figure 6) until the menu option
«DESCALE» appears.
0 Confirm the menu option with the
"OK" button (Figure 6). The display
shows «DESCALE NO».
0 Press thescrolling button "<", and the
display shows «DESCALE YES».
0 Confirm with the "OK" button
(Figure 6). The descaling programme
starts.
3 If "OK" is not pressed, the appliance
automatically returns to the coffee
mode after about 120 seconds and the
descaling programme is not started.
The top line of the display alternates
between «ADD DESCALER» and
«PRESS MENU KEY» whilst the
bottom of the display shows a progress
bar and percentage,
«
0%».
0 Empty the water tank, fill it with at
least 1 litre of water and add the des-
caling agent.
1 Warning: Make sure that any splashes
from the descaling agent do not come
into contact with surfaces that are
sensitive to acids, such as marble, lime-
stone and ceramic.
0 Insert the hot water nozzle (Figure 10).
0 Put a container with a capacity of at
least 1.5 litres underneath the hot
water nozzle.
0 Press the "MENU" button (Figure 5).
The descaling programmestarts and the
descaling liquid runs out of the hot
water nozzle. The display shows
«DESCALING» and a progress bar
shown with a percentage, e.g.
«
25%».
The descaling programme automati-
cally goes through a series of rinses
and pauses to remove limescale depos-
its from the inside of the coffee
machine.
After about 45 minutes the water tank
is empty and the top line of the display
alternates between «DESCALE
COMPLETE» and «PRESS MENU
KEY» whilst the bottom line shows a
progress bar and a percentage
«
50%».
0 Press the "MENU" button (Figure 5).
The appliance is now ready for a rins-
ing process with clean water. The top
line of the display alternates between
«RINSING» and «FILL TANK !»
whilst the bottom of the display shows
a progress bar and percentage
«
50%».
0 Take out the water tank, fill it with
clean water and put it back in place.
The top line of the display alternates
between «RINSING» and «PRESS
MENU KEY» whilst the bottom of the
display shows a progress bar and per-
centage
«
50%».
0 Empty the container under the hot
water nozzle and put it back under the
hot water nozzle.
0 Press the "MENU" button (Figure 5).
A rinsing process takes place with clean
water and the rinsing water runs out
of the hot water nozzle. The display
shows «RINSING » and a progress
bar shown with a percentage, e.g.
«
55%».
After a few minutes the water tank is
empty and the top line of the display
alternates between «RINSING
COMPLETE» and «PRESS MENU
KEY» whilst the bottom line shows a
progress bar and a percentage
«
90%».
0 Press the "MENU" button (Figure 5).
For a short time the top line of the dis-
play alternates between «RINSING
COMPLETE» and «FILL TANK !»
whilst the bottom line of the display
822_949_354 ECG6600-East_Elux.book Seite 134 Freitag, 1. Februar 2008 11:36 23