Electrolux ECG6600 - Manual (Page 117)

g
117
4 Summary of menu options
Below you will find a summary of the
menu options, which are used to
change and save the appliance's fac-
tory settings, as well as to start pro-
grammes and look up information. You
will find detailed information about
this in the subsequent chapters of this
instruction manual.
• «CHOOSE LANGUAGE» menu
Display language - there is a choice of
several languages.
• «WATER HARDNESS» menu
Programmable level of hardness bet-
ween 1 (soft) and 4 (very hard).
Factory setting: 4 (very hard).
• «TEMPERATURE» menu
Programmable coffee temperature bet-
weenLOW, MEDIUM and HIGH.
Factory setting: HIGH
• «AUTO SHUTOFF TIME» menu
Programmable switch-off time bet-
ween 1 hour and 3 hours.
Factory setting: 1h (1 hour).
• «JUG PROGRAM» menu
Programmable filling quantity (cup
size) and amount of ground coffee
(coffee strength) for cups being made
in the jug.
• «COFFEE PROGRAM» menu
Adjust filling quantity for any cup size
(espresso cup, small cup, medium cup,
large cup, mug).
• «CAPPUCCINO PROGRAM»
menu
Adjust quantity of milk or coffee for
cappuccino.
• «HOT WATER PROGRAM»
menu
Adjust quantity of hot water.
• «DESCALE» menu
Start the descaling procedure.
• «STATISTICS» menu
Look up number of cups of coffee
made, number of jugs with 4, 6, 8 or 10
cups or number of descaling proce-
dures carried out.
• «RESET TO DEFAULT» menu
Reset the changed appliance settings
to factory settings.
5 Menu mode
Pressing the "MENU" button (Figure 5)
switches to menu mode. In menu
mode, the buttons"1 cup of coffee"
, "2 cups of coffee“" , "hot
water" and "MENU" are used to nav-
igate. The respective function is shown
above the button in the display
(Figure 6):
• «<» ("1 cup of coffee" ) and
«>» ("2 cups of coffee" ) allow you
to "scroll" in the menu
• «OK» ("hot water" ) confirms a menu
option
• «ESC» ("MENU") returns to the last
menu level without making any
changes
6 Using for the first time
6.1 Setting up appliance and
connecting it
Choose a suitable surface that is hori-
zontal, stable, unheated, dry and
waterproof.
1 Make sure that air can circulate well.
There must be a gap of at least 5 cm at
each side and behind the appliance,
and at least 20 cm above the appli-
ance.
The appliance must not be installed in
areas where temperatures of 0°C and
below can arise (damage to appliance
due to freezing water).
1 Warning! If the appliance is installed in
a warm area after coming out of the
cold, wait approx. 2 hours before
switching on!
We recommend laying a suitable base
under the appliance to prevent damage
from splashes.
0 Only connect the appliance to an
earthed socket. Do not use an
unearthed socket.
822_949_354 ECG6600-East_Elux.book Seite 117 Freitag, 1. Februar 2008 11:36 23