11 preparing hot water – Electrolux ECG6600 User Manual
Page 125
g
125
fixed in the «CAPPUCCINO PRO-
GRAM» menu.
0 Swing the milk dispenser pipe out
(Figure 28) and place a sufficiently big
cup underneath the coffee dispenser
and the milk dispenser pipe.
0 Press once on the "jug/cappuccino"
button
(Figure 29).
Hot and frothy milk, then coffee, are
dispensed into the cup.
The top line of the display shows
«CAPPUCCINO» and on the bottom
line a progress bar and percentage are
displayed, e.g.
«
40%»
which shows progress of the cappuc-
cino being made.
3
The amount of milk and coffee is pre-
set to normal quantities. You can
change and save these to suit your
taste, see „Setting the cappuccino pro-
gramme (programming the quantity of
milk and coffee)“ page 129.
After a few seconds the appliance is
ready for use again. The display shows
the last selected coffee setting.
10.2
Frothing/heating up milk
0 Swing the milk dispensing pipe out
(Figure 28) and place a sufficiently big
cup underneath the milk dispensing
pipe.
0 Press twice on the "jug/cappuccino"
button
(Figure 29) (within
2 seconds of each other).
Hot and frothy milk is dispensed into
the cup.
The top line of the display shows
«MILK FROTHING» and on the bot-
tom line a progress bar and percentage
are displayed, e.g.
«
40%»
which shows progress of the milk
frothing process.
3
The amount of milk is preset to a nor-
mal quantity. You can change and save
this to suit your taste, see „Setting the
cappuccino programme (programming
the quantity of milk and coffee)“
page 129.
After a few seconds the appliance is
ready for use again. The display shows
the last selected coffee setting.
10.3
Cleaning the nozzles
Every time after heating milk or mak-
ing cappuccino, the nozzles on the milk
container have to be cleaned as fol-
lows, otherwise remains of milk can set
hard:
0 Place a container under the milk dis-
penser pipe and press on the "CLEAN"
button on the milk container
(Figure 30) for at least 5 seconds. The
display shows «CLEANING».
1
Warning! Risk of scalding from steam
and hot water escaping from the milk
dispenser pipe.
0 Now remove the milk container and
clean the nozzles on the appliance
with a damp cloth (Figure 31).
0 Put the hot water nozzle back in
(Figure 10).
3
When you have finished cleaning, take
the milk container off and place it in the
fridge. The milk should not stay out of
the fridge for longer than 15 minutes.
11
Preparing hot water
Hot water can be used to warm up
cups andto make hot drinks, such as
tea or packet soups.
1
Warning! Risk of scalding when the hot
water nozzle is activated! Escaping hot
water can lead to scalds. Only activate
the hot water nozzle when there is a
receptacle under the hot water nozzle.
0 Put the hot water nozzle in place
(Figure 10).
0 Place a container underneath the hot
water nozzle.
0 Press the "hot water" button (Figure
32). Hot water is dispensed; the display
shows «HOT WATER» Once the pro-
grammed amount of hot water has
822_949_354 ECG6600-East_Elux.book Seite 125 Freitag, 1. Februar 2008 11:36 23