Electrolux ECG6600 - Manual (Page 124)

g
124
the appliance is ready again can
ground coffee be inserted for the next
cup. Never insert ground coffee when
the machine is switched off, otherwise
it will be spread all over the inside of
the appliance.
1 Only use ground coffee suitable for
fully automatic espresso machines. Do
not put any coffee beans, any water
soluble, freeze dried instant powders or
any other drinking powders into the
chute. Ground coffee that is too fine
can lead to blockages.
3 If the filling chute is blocked (due to
damp in the appliance or because more
than 2 measuring spoons have been
inserted), use a knife or spoon handle
to push the ground coffee down
(Figure 23). Next remove the brewing
unit and clean it together with the
coffee machine as described below
„Cleaning the brewing unit“ page 132".
0 Close the cover.
3 If no button is pressed for a few sec-
onds after selecting the "preground
coffee" function, the appliance sug-
gests the next step on its display:
«PRESS 1 OR 2 CUPS KEY».
0 Select the desired cup size with the
"cup size" knob (Figure 13). The
selected cup size is displayed.
0 Press the "1 cup of coffee" button to
make one cup, or the "2 cups" button
for 2 cups.
The coffee is made.
3 To return to the mode for coffee beans
after making the coffee, turn the "cof-
fee strength / preground coffee" knob
(Figure 21) to any coffee strength set-
ting (the coffee grinding mill is re-ena-
bled).
10 Making cappuccino or hot
milk (coffee and milk
froth)
You can use this function to either
make hot, frothy milk or cappucino in
a single process.
0 Unfasten the lid of the milk container
with a slight clockwise turn and
remove it.
0 Fill the container with sufficient milk
(Figure 24). Do not go over the MAX
line engraved on the container handle
(comes to about 1000 ml).
3 Preferably skimmed or semi-skimmed
milk at fridge temperature (about 5 °C)
should be used.
0 Make sure that the suction pipe is cor-
rectly inserted (Figure 25); next place
the lid back on the milk container and
fasten it with a slight anti-clockwise
turn.
0 Pull the hot water spout off (Figure 10)
and bring the milk container up to the
nozzle (Figure 26). Make sure that the
milk container is correctly put in place.
0 You can set the amount of froth on the
milk to any level using the slider on the
lid (Figure 27).
– Position "1 CAPPUCCINO": very
frothy milk.
– Position "2 CAFFELATTE": not so
frothy milk.
3 Once the milk container is put in place,
the appliance suggests the next step
on the display: «PRESS JUG KEY
X1 FOR CAPPUCCINO, X2 FOR
MILK ONLY».
10.1 Making cappuccino
0 Select the desired coffee strength for
the cappuccino with the "coffee
strength" knob (Figure 14). The
selected coffee strength is displayed.
3 The cup size on the top line (e.g.
«ESPRESSO CUP») has no meaning
here, as the amount of coffee made is
822_949_354 ECG6600-East_Elux.book Seite 124 Freitag, 1. Februar 2008 11:36 23