Electrolux ECG6600 - Manual (Page 126)

g
126
been dispensed, dispensing stops auto-
matically.
For a few seconds the display shows
«PLEASE WAIT...». After that the
appliance is ready to make coffee
again and the last selected coffee set-
ting appears on the display.
3 The appliance is set to a normal quantity
at the factory. You can change and save
this to what you want, see „Setting the
hot water programme (programming
dispensing quantity)“ page 130.
3 It is not recommended to pour off hot
water for longer than 2 minutes with-
out a break.
0 You can stop hot water from dispens-
ing at any time. To do so, press the "hot
water" button again (Figure 32).
12 Setting the grind level
The mill mechanism is set at the fac-
tory to a medium grind level. If coffee
is dispensed too quickly or too slowly
(in drips), you can change the grind
level during the milling process.
1 The grind level can only be changed
during the milling process. Changing
the settings when the mill mecha-
nism is at rest can damage the coffee
machine.
0 Adjust the grind level with the knob
for setting the grind level (Figure 2, T)
(Figure 12).
• If the coffee only comes out in drips
or not at all, the knob must be
turned by one position clockwise.
Turn one position at a time until
coffee is dispensed satisfactorily.
• If the coffee comes out too fast and
the crema does not meet your taste,
turn the knob by one position anti-
clockwise.
3 Make sure that you do not turn the
knob for setting the grind level too far,
as otherwise coffee may come out in
drips when dispensing 2 cups.
3 You will only notice the effect of these
corrections after at least 2 more cof-
fees have been made, however.
Removing foreign bodies in the mill
mechanism.
Foreign bodies in the mill mechanism,
such as small stones, can damage the
mechanism. A foreign body in the cof-
fee causes an even rattling noise. If you
hear this noise during the milling pro-
cess, switch the appliance off immedi-
ately and consult customer services.
Blocking or damage caused by for-
eign objects in the grinder might be
excluded from the guarantee.
13 Menu settings
13.1 Setting the language
You can choose between several langu-
ages. A different language can be
selected as follows:
0 Press the "MENU" button (Figure 5).
The menu option «CHOOSE LAN-
GUAGE» appears.
0 Confirm the menu option with the
"OK" button (Figure 6). The language
set appears on the display.
0 Press the scrolling buttons "<" or ">"
(Figure 6) until desired language
appears.
0 When the desired language is dis-
played, confirm it with the"OK" button
(Figure 6). This language is program-
med in accordingly.
If "OK" is not pressed, the appliance
automatically returns to the coffee
mode after about 120 seconds without
saving the entries.
3 The display automatically jumps back
to the menu option «CHOOSE LAN-
GUAGE» after programming.
0 To go back to the coffee mode, press
the "MENU" button (Figure 5)or wait
about 120 seconds until the appliance
automatically jumps back to coffee
mode.
822_949_354 ECG6600-East_Elux.book Seite 126 Freitag, 1. Februar 2008 11:36 23