Transition Networks SISPM1040-182D - Manual (Page 54)

Transition Networks SISPM1040-182D
Technical Support: 1-800-260-1312 International: 00-1-952-941-7600
6.8 System Event Log
This page allows the user to decide whether to send the system event log, and select the
mode which the system event log will be sent to client only, server only, or both client
and server. What kind of event log will be issued to the client/server depends on the
selection on the Event Configuration tab. There are five types of events—Device Cold
Start, Device Warm Start, Authentication Failure, X-Ring Topology Change, and Port
Event—available to be issued as the event log.
6.8.1 Syslog Configuration
„ Syslog Client Mode: Select the system log mode—Client Only, Server Only, or
Both. ‘Client Only’ means the system event log will only be sent to this interface of the
switch. ‘Server Only’ means the system log will only be sent to the remote system
log server with its IP assigned. If the mode is set to ‘Both’, the system event log will be
sent to the remote server and this interface.
„ System Log Server IP Address: When the ‘Syslog Mode’ item is set as Server
Only/Both, the user has to assign the system log server IP address to which the log
will be sent.
„ Click Reload to refresh the event log displaying area.
„ Click Clear to clear all the current event logs.
„ Make sure the selected mode is correct, and click Apply to have the setting take
effect.