beautypg.com

Removing/replacing hdd connector board – Texas Instruments EXTENSA 570CD User Manual

Page 72

background image

4.

Lift up on the front edge of the main board until it clears the battery
cavity; then pull the main board forward and out of the plastics.

5.

Reassembly is the reverse of steps 1 through 4 above.

6.5.14

Removing/Replacing HDD Connector Board

To remove and replace the HDD connector board Assembly, perform the
following procedure:

1.

Remove the top case assembly as described in Paragraph 6.5.8.

2.

Remove the main board assembly as described in Paragraph 6.5.13.

3.

Turn the main board over and lay on a flat surface.

4.

Using a small Phillips screwdriver, remove the two screws securing
the HDD connector board to the main board.

5.

Replacement is the reverse of Steps 1 through 4.

New P/S
Board

Remove all other board
assemblies; then remove four
Hex Standoffs and four screws.

Main Board
Assembly

Figure 6-4 Replacing the Main Board Assembly

6-14 Field Service